Available for Pre-Order Now
COMING SOON!!! Crown Squire Laser Cut Balsa Low Wing Trainer Kit
Laser Cut Kit for the AdamSky RC Crown Squire
Our second kit here at AdamSky RC. The Crown Squire is the fraternal twin to the Cadet and is a 3ch Rudder, Elevator, and Throttle Low wing Taildragger. It features a wingspan of just over 25" and is a little more than 17" long. Once built, the flying weight should be under 75g. An excellent power-to-weight ratio and ultra-light wing loading create an enjoyable flight experience for more than 10 minutes at a time with the recommended 1s300 battery.
AdamSky RC Crown Squire Laser Cut Kit includes-
- Hand Selected Laser Cut1/16" balsa wood flat parts (7 Sheets)
- 1/16" sq balsa stringer, 1/8" balsa pushrods
- .8mm music wire landing gear wire
- .2mm music wire pushrod ends
- 1/8"x 1/2" trailing edge balsa
- 1/16" Ply parts (firewall, spar joiner, control horns)
- Brass crimp Wheel Collars (x2)
- White domestic tissue (x4)
- Rare earth hatch magnets (x2)
- Full size rolled plans
**Items needed to complete**
- Glue PVA/ CA
- Sandpaper/ Emery Board
- Sharp Knife/ Scalpel
- Pins
- Surface to build on
PLEASE ALLOW 1-3 DAYS PROCESSING
**Components required to fly
- 1103-6000kv or 1204-5000kv Motor
- RX4T Receiver with JST-PH 2.0 connector
- 2 1.7g servos
- 1s300 Lipo Battery with JST-PH 2.0 connector
- GWS4530-4540 propeller and prop adapter
- Transmitter with either AFHDS, DSMX/2, or Frsky D16 Protocol.
***Kit contains small parts not recommended for children under 10 years of age. Adult supervision required***