Laser Cut Kit for the AdamSky RC Crown Cadet
Our first kit here at AdamSky RC. The Crown Cadet is a 3ch Rudder, Elevator, and Throttle Highwing Taildragger. It features a wingspan of just over 25" and is a little more than 17" long. Once built, the flying weight should be under 75g. An excellent power-to-weight ratio and ultra-light wing loading create an enjoyable flight experience for more than 10 minutes at a time with the recommended 1s300 battery.
AdamSky RC Crown Cadet Laser Cut Kit includes-
- Hand Selected Laser Cut1/16" balsa wood flat parts (7 Sheets)
- 1/16" sq balsa stringer, 1/8" balsa pushrods
- .8mm music wire landing gear wire
- .2mm music wire pushrod ends
- 1/8"x 1/2" trailing edge balsa
- 1/16" Ply parts (firewall, spar joiner, control horns)
- Brass crimp Wheel Collars (x2)
- White domestic tissue (x4)
- Rare earth hatch magnets (x2)
- Full size rolled plans
**Items needed to complete**
- Glue PVA/ CA
- Sandpaper/ Emery Board
- Sharp Knife/ Scalpel
- Pins
- Surface to build on
PLEASE ALLOW 1-3 DAYS PROCESSING
**Components required to fly
- 1103-6000kv or 1204-5000kv Motor
- RX4T Receiver with JST-PH 2.0 connector
- 2 1.7g servos
- 1s300 Lipo Battery with JST-PH 2.0 connector
- GWS4530-4540 propeller and prop adapter
- Transmitter with either AFHDS, DSMX/2, or Frsky D16 Protocol.
***Kit contains small parts not recommended for children under 10 years of age. Adult supervision required***